These Bell 7-Series tear-offs (BEL2030002) are a pack of ten 0.25mm clear films for the SE07 visor used on the RS7 Carbon, RS7 Pro, RS7-K and HP7. Tear-offs sit in stacked layers over the outside of the visor; during a race, a pull on the tab at the edge removes the outermost layer in a single motion, leaving a clean surface underneath without the driver needing to wipe the visor with a hand.
At 0.25mm, each layer adds minimal optical distortion while providing good resistance to stone chip damage. A full pack of ten gives enough films for multiple race weekends. In sprint racing, three or four layers per session is a reasonable setup; in endurance events, the stack can be built higher and the removal cadence planned to match the expected conditions.
Tear-offs are visor-specific: this pack fits the SE07 3mm shield only. If your Bell helmet uses the SE03 3mm visor (GP3 Sport, GP3 Carbon), the Bell 3/5-Series Tear-Offs (BEL2030001) are the correct part. The two versions are not interchangeable because the mounting tabs are positioned differently.






